![]() This is just one more reason to be grateful to those who devote their time and energy to the development and testing of the Clover bootloader. It works like a dream and my NVMe drive is super-fast on this rig and its temperature stays in the mid 30's Celsius because there is lots of space for it and several well-placed cooling fans. I then went into the BIOS, changed the boot order so that it would boot from the mSATA Clover partition, and set it up to boot via UEFI. I added the nvme efi driver and the grub ntfs driver. I found the tutorial below and used CVAD's Bootdisk Utility (BDU) to install Clover - first to a USB drive for testing purposes and subsequently, to the mSATA drive I am no longer using as my system drive. That support started with the Z97 chipset. The Z87 chipset has no support for NVMe drives. This is similar to my Clover and rEFInd script, but no need for a fancy GUI as some people just prefer to boot straight to SteamOS. I recommend you download BootDiskUtilit yand use it to install Clover onto a spare USB Flash drive. As a result, I could only use it as a storage drive, not as a boot drive. The script will automatically re-create the SteamOS EFI entry in case a SteamOS / BIOS update breaks it just boot to steamcl.efi and it will fix it automatically. I bought a 4x adapter for the NVMe drive and it was recognized in Windows but not in the BIOS. The adapter had its own firmware that allowed it to be recognized in the BIOS. ![]() My system disk for that computer was an mSATA 256 GB which was connected to the computer via an adapter connected to a 1x pci-e slot. Finally, I moved the Clover bootloader to a SATA SSD and the system is now automatically booting to Windows without the Clover GUI. Once Windows was up and running, I tried the Clover USB stick again and it successfully booted to Windows. I decided to put it into my Windows 10 desktop gaming computer, which has a Z87 chipset, Haswell i7 processor and other features appropriate for a gaming rig. However, when I booted from a DUETEDK2020REFIND USB stick, the Windows installation went fine. I notice no performance decrease with the SATA SSD and its temperature has never exceeded the low 50's Celsius and is usually in the high 30's. Use Clover USB to boot into Clover and choose, start Windows EFI to boot into NVME. Log into Win10 on SSD and convert NVME from MBR to GPT. ![]() Install cloner (I use Macrium Reflect) and clone Win10 SSD to NVME 4. Before the heat of summer set in, I decided to swap out the NVMe drive and replace it with a 1 TB M.2 SATA SSD. Follow NVME/Clover thread to set up Clover USB. Even with a heatsink, the drive ran well into the 70's Celsius, which felt uncomfortably warm on my leg (yes, I actually use a laptop on my lap.). The NVMe drive, however, turned out to be a disappointment due to heat problems caused by the lack of space inside the ultra-thin HP laptop. When I bought my HP Envy 17t-ae100, I also bought several upgrades including a 512 GB NVMe M.2 drive.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |